Montana AWD V6-3.4L VIN E (2004)
6.3.Connect the J 35944-A discharge hose (1) to the oil cooler feed pipe, radiator end.
6.4.Clip the discharge hose (1) onto the oil drain container.
6.5.Start the engine with the transmission in PARK range and run for 30 seconds after fluid begins to flow from the discharge hose (1). A
minimum of 1.9 L (2 qt) must be discharged during this 30 second run time.
7. If the amount of transmission fluid flow remains less than 1.9 L (2 qt) in 30 seconds, inspect the oil cooler feed pipe, top connector, for
restrictions or damage. If no condition is found with the feed pipe, inspect the transmission.
Clean-up
1. Disconnect the water supply hose from the J35944-A and bleed any remaining air pressure from the flusher tank.
2. Remove the fill cap from the J 35944-A and return any unused flushing solution to its container. Rinse the J35944-4 with water. Do not store the J
35944 A with flushing solution in it.
3. After every third use, clean the J 35944-A as described in the instructions included with the tool.
4. Dispose of any waste water/solution and transmission fluid in accordance with local regulations.