Montana AWD V6-3.4L VIN E (2004)
4. Push the propeller shaft toward the rear of the vehicle and install the propeller shaft to the transfer case flange.
5. Align the reference marks on the propeller shaft and the transfer case flange.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the propeller shaft-to-transfer case bolts. Ensure that the crescent washer is in place on each pair of bolts.
7. Tighten the bolts in a cross sequence.
^
Tighten the bolts to 33 Nm (24 ft. lbs.).
8. Tighten the propeller shaft to torque tube bolts in a cross sequence.
^
Tighten the bolts to 33 Nm (24 ft. lbs.).
9. Lower the vehicle.
