Montana AWD V6-3.4L VIN E (2004)
1. Place the new small seal clamp (2) onto the small end of the joint seal (1). Slide the joint seal and the small seal clamp onto the wheel drive shaft
bar.
2. Position the small end of the joint seal into the ENS joint seal groove (3) on the wheel drive shaft bar.
Notice: Refer to Fastener Notice in Service Precautions.
3. Using the J 42572, crimp the small seal retaining clamp.
^
Tighten the clamp to 136 Nm (100 ft. lbs.).
4. Install a new barrel retaining ring to the wheel drive shaft bar.
Important: The proper 60 degree offset relationship between the inner and outer tripot spiders must be maintained.
5. Align the reference mark on the tripot spider and the wheel drive shaft bar.
