Montana AWD V6-3.4L VIN E (2004)
Wiper Motor: Service and Repair
Wiper Motor Cover Replacement - Rear
WIPER MOTOR COVER REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the liftgate trim panel.
2. Disconnect the rear wiper motor module electrical connector.
3. Using a small flat-bladed tool, remove the rear wiper motor module cover.
4. Remove the rear wiper motor module circuit board from the rear wiper motor.
INSTALLATION PROCEDURE
1. Position the rear wiper motor module circuit board to the rear wiper motor, pressing in until fully seated.
