Montana FWD V6-3.4L VIN E (2005)
6. Remove the mode actuator mounting screws.
7. Remove the mode door actuator.
INSTALLATION PROCEDURE
1. Install the mode actuator.
2. Install the mode actuator mounting screws.
Tighten the screws to 1.6 N.m (14 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the I/P wiring harness clip to the I/P support bracket.
4. Connect the mode actuator push rod (2) to the retainer clip (1).
IMPORTANT: Align the counted number of threads on the mode actuator push rod (2) with the tip of the retainer clip (1).
5. Close the push rod retainer clip (1).
6. Connect the mode actuator electrical connector.
7. Install the knee bolster.
Mode Actuator - Auxiliary
MODE ACTUATOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the left lower quarter trim panel.
2. Disconnect the auxiliary mode actuator electrical connector.
3. Remove the auxiliary mode actuator retaining screws.
4. Remove the auxiliary mode actuator from the air distribution duct.
INSTALLATION PROCEDURE