Montana FWD V6-3.4L VIN E (2005)
2. Important:
DO NOT ROTATE A NEW PNP SWITCH. A new PNP switch is produced in the Neutral position. If the bolt holes do not align with the holes in
the transaxle, verify that the transmission is in Neutral.
Adjust the PNP switch if the new switch has been rotated and the pin is broken or if using an old PNP switch.
Align the flats of the shift shaft to the flats in the PNP switch.
3. Install the PNP switch to the transaxle.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the PNP switch bolts.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
5. Install the automatic transaxle range selector lever.
6. Install the electrical connectors.
7. Install the automatic transaxle range selector cable.
Important: Verify that the engine starts ONLY with the transmission in Park or Neutral. Adjust as necessary.
8. Install the throttle body air inlet duct.
9. Remove the blocks from the wheels.
10. Release the parking brake.