Montana FWD V6-3.4L VIN E (2005)
Air Cleaner Fresh Air Duct/Hose: Service and Repair
AIR CLEANER INTAKE DUCT REPLACEMENT
REMOVAL PROCEDURE
1. Loosen the 2 intake air duct clamps (1) from the mass airflow (MAF) sensor (2) and the throttle body.
2. Remove the intake air temperature (IAT) sensor from the duct.
3. Disconnect the vent tube from the air intake duct.
4. Disconnect the MAF sensor electrical connector.
5. Unlatch the air cleaner cover clips (1) and remove the air intake duct and air cleaner cover.
6. Separate the air intake duct from the MAF sensor.
INSTALLATION PROCEDURE
1. Install the air intake duct to the MAF sensor.
2. Install the air intake duct to the throttle body and the air cleaner cover to the air cleaner assembly.
3. Latch the air cleaner cover clips (1).
4. Reconnect the MAF sensor electrical connector (2).
5. Reconnect the vent tube to the air intake duct.
6. Install the IAT sensor.
7. Tighten the 2 intake air duct clamps (1).
NOTE: Refer to Fastener Notice in Service Precautions.