Solstice L4-2.0L Turbo (2008)
Steering Wheel Controls Switch - Left
1. Ignition OFF, remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement (See:
Restraint Systems/Air Bag Systems/Air Bag/Service and Repair) .
2. Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.
3. Measure the resistance between the supply voltage circuit terminal 4 and the signal circuit terminal 5. Individually activate and hold each cruise
control function switch and compare the resistance reading to the values for the On, Off, SET -, RES +, and Cancel switches.
‹› If any of the resistance measurements for the On, Off, SET -, RES + and Cancel switches are not within the listed resistance values, replace the
steering wheel controls - left.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
Steering Wheel Control Switch Assembly Replacement (See: Accessories and Optional Equipment/Sensors and Switches - Accessories and
Optional Equipment/Steering Mounted Controls Assembly/Service and Repair)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM or ECM replacement, setup, and programming