Torrent AWD V6-3.4L VIN F (2006)
1. Important: Provided the rear main bearing cap and engine front cover have not been removed and provided the sealant on either side of the rear
main bearing cap and engine front cover has not been disturbed, it may not be necessary to apply additional sealant in these locations.
Apply sealer GM P/N 12378521 (Canadian P/N 88901148) or the equivalent, to both sides of the crankshaft rear main bearing cap (1) and where
the engine front cover meets the engine block. Press the sealer into the gap using a putty knife.
2. Install the oil pan gasket.
3. Install the oil pan.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the oil pan flange bolts.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
5. Install the oil pan side bolts.
^
Using J 39505 torque the bolts to 50 Nm (37 ft. lbs.).
6. Install a NEW oil filter.
7. Install the frame.
8. If equipped with FWD, install the intermediate shaft.
9. If equipped with AWD, install the transfer case.
10. Install the starter.