pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Relay Module > < Global Positioning System Module|Locations|Page 174
Page 2
background image

2. Connect the electrical connectors, the GPS antenna, and the cellular coax cable.
3. Tilt the CIM inboard and install the CIM.

4. Install the CIM fastener.

Tighten the fastener to 10 N.m (89 lb in).

NOTE:  Refer to Fastener Notice in Service Precautions.

5. Reconfigure the OnStar(R) system. Refer to OnStar Reconfiguration.

IMPORTANT:  After replacing the vehicle communication interface module, you must reconfigure the OnStar(R) system. Failure to reconfigure the
system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this
version of the OnStar(R) system. This action will cause a DTC to set.

Relay Module > < Global Positioning System Module|Locations|Page 174