pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Fluid - A/T|Capacity Specifications|Page 9493 > < Fluid - A/T|Capacity Specifications|Page 9491
Page 2
background image

10. If the fluid level is incorrect inspect for the following conditions:

^

Fluid below level, inspect for a leak. Refer to Fluid Leak Diagnosis or Automatic Transmission Fluid Leaks. See: Testing and
Inspection/Component Tests and General Diagnostics/Fluid Leak Diagnosis See: Testing and Inspection/Component Tests and General
Diagnostics/Automatic Transmission Fluid Leaks

^

Fluid above level, inspect for contamination of the fluid. 

11. Important: The transaxle uses T-IV fluid, GM P/N 88900925 (Canadian P/N 22689186). The fluid is normally red in color. The oil may darken

in color with more miles on a vehicle. 

Inspect the condition of the fluid for the following conditions:
^

Excessively dirty with particles in the fluid
^

If there are no DRIVEABILITY concerns, replace the fluid. 

^

If DRIVEABILITY concerns are present disassemble and inspect for a cause. 

^

Burnt smell
^

Inspect for the correct fluid. Refer to Fluid Capacity Specifications. 

^

Inspect for conditions that may of cause overheating of the transmission fluid. Refer to Transmission Overheats. See: Testing and
Inspection/Symptom Related Diagnostic Procedures/Transmission Overheats

^

If there are no DRIVEABILITY concerns, replace the fluid. 

^

If DRIVEABILITY concerns are present disassemble and inspect for cause. 

^

Inspect the transmission oil cooler system for functioning properly. 

^

Black in color
^

Disassemble the transaxle and inspect for components that may have over heated. 

^

Inspect the transmission oil cooler system for functioning properly. 

^

Milky or white tint in color from coolant or water
^

Inspect for failure of the transaxle oil cooler. Refer to Engine Coolant/Water in Transmission. See: Testing and Inspection/Symptom
Related Diagnostic Procedures/Engine Coolant/Water In Transmission

^

Inspect for missing or improperly routed vent hose. 

^

Inspect for missing fill plug. 

12. Install the fluid level indicator. 

13. Notice: Refer to Fastener Notice in Service Precautions. 

Install the fluid indicator bolt. 
^

Tighten the fluid indicator bolt to 10 Nm (89 inch lbs.)

Fluid - A/T|Capacity Specifications|Page 9493 > < Fluid - A/T|Capacity Specifications|Page 9491