Torrent AWD V6-3.4L VIN F (2006)
1. Position the RDM support bushing to the vehicle frame with the slotted portions of the bushing at the 6 o'clock and 12 o'clock positions.
2. Install the receiver end of the J 44866 against the vehicle frame opposite the bushing.
3. Place the large diameter face of the J 44866 driver against the flanged portion of the bushing.
4. Install the bolt and washer through the driver, bushing, and receiver.
5. Install the nut to the bolt.
6. Slowly tighten the bolt and nut until the bushing is drawn into the vehicle frame and the flange is seated squared against the vehicle frame.
7. Remove the J 44866 .
8. Install the support bracket (2) to the RDM.
9. Install the bolt (3) and nut (1) to the bracket.
10. Notice: Refer to Fastener Notice in Service Precautions.
Tighten the support bracket nut and bolt.
^
Tighten the bolt and nut to 105 Nm (77 ft. lbs.).
