Torrent AWD V6-3.6L (2008)
11. Remove the caps from the fuel and EVAP lines.
12. Connect the fuel feed pipe quick connect fitting (3) to the fuel rail.
13. Connect the EVAP pipe quick connect fitting (3) to the EVAP purge solenoid.
14. Connect the negative battery cable.
15. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure).
16. Prime the fuel system.
1. Cycle the ignition ON for 5 seconds and then OFF for 10 seconds. Repeat cycling twice.
2. Crank the engine until it starts. The maximum starter motor cranking time is 20 seconds.
3. If the engine does not start, repeat the above steps.
17. Run the engine and check the system for leaks.
