Torrent FWD V6-3.4L (2007)
2. Position the heater element over the seat foam pad and align the tabs and holes of the heater element to the seat foam. Press firmly to engage the
adhesive.
3. Route the heating element wiring harness under the seat pad and connect the harness to the heater module. Secure the wire with tie straps.
4. Install the seat cushion cover and pad.
5. Install the front seat to the vehicle.
6. IMPORTANT: Perform the passenger presence system preload test procedure when performing any repairs to the passenger seat.
Preload test the inflatable restraint passenger presence system for the front passenger seat. Refer to Control Module References. See: Testing and
Inspection/Programming and Relearning