Torrent FWD V6-3.4L (2007)
Exhaust Pipe: Service and Repair
Exhaust Crossover Pipe Replacement
Removal Procedure
1. Remove the battery box.
2. Remove the exhaust crossover pipe nuts (2).
3. Remove the exhaust crossover pipe (3).
4. Remove the exhaust manifold studs (1), if replacement of the stud is necessary.
Installation Procedure
Notice: Refer to Fastener Notice .
1. Install any previously removed exhaust manifold studs (1).
Tighten the studs to 25 N.m (18 lb ft).
2. Install the exhaust crossover pipe (3).
Important: Maintain approximately 6.35 mm (0.25 in) between the thermostat housing and the exhaust crossover pipe.
3. Install the exhaust crossover pipe nuts (2).
Tighten the nuts to 25 N.m (18 lb ft).