Torrent FWD V6-3.4L (2007)
4. Insert the Weather Pack(R) terminal removal tool J 38125-10A (GM P/N 12014012-1) into the front (mating end) of the connector cavity until it
rests on the cavity shoulder (1).
5. Gently pull on the wire to remove the terminal through the back of the connector (2).
IMPORTANT: Never use force to remove a terminal from a connector.
6. Inspect the terminal and connector for damage. Repair as necessary.
7. Reform the lock tang (2) and reset terminal in connector body.
8. Close secondary locks and join connector halves.
9. Verify that circuit is complete and working satisfactorily.
10. Perform system check.
Delphi Connectors (12 Way)
DELPHI CONNECTORS (12-WAY)
TOOLS REQUIRED
J-38125 TERMINAL REPAIR Kit
REMOVAL PROCEDURE
Follow the steps below in order to remove terminals from the connector.
1. Locate the lever lock on the wire dress cover. Remove the connector position assurance (CPA) and slide the lever lock away from the connector
body.
2. Disconnect the connector from the component.