Torrent FWD V6-3.4L (2007)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Replacement
CRANKSHAFT POSITION SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Disconnect the crankshaft position (CKP) sensor electrical connector.
3. Remove the CKP sensor nut (2).
4. Remove the CKP sensor (1) from the engine.
5. Inspect for wear, cracks, or leakage if the CKP sensor is being reused.
INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil. Replace the O-rings if damaged.
2. Install the CKP sensor (1) to the block.
3. NOTE: Refer to Fastener Notice.