Torrent FWD V6-3.4L (2007)
4. Install the nut (1) retaining the heater outlet pipe.
Tighten the nut to 25 N.m (18 lb ft).
5. Install the engine wire harness retainers to the ignition control module bracket studs (5).
6. Install the bolt (3) from the fuel injector wire harness bracket (4) and PCV valve fresh air tube retainer.
Tighten the bolts to 5 N.m (44 lb in).
7. Install the ignition coil/control module to the ignition control module bracket.
8. Install the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
Tighten the bolts to 4.5 N.m (40 lb in).
9. Install the spark plug wire retainer (1) to the ignition control module bracket.
10. Connect the ignition coil/control module electrical connectors.
11. Install the injector sight shield.
