Torrent FWD V6-3.4L (2007)
Fluid Line/Hose: Service and Repair
Fluid Cooler Pipe Seal Replacement
Fluid Cooler Pipe Seal Replacement
Tools Required
*
J 41239-1A Cooler Line Seal Installer
*
J 45201 Cooler Line Seal Remover
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a
hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
2. Place a drain pan or suitable container under the vehicle.
3. Remove the transaxle oil cooler line assembly nut from the transaxle.
4. Disconnect the transaxle oil cooler lines from the vehicle.
Important: Ensure that the J 45201 is fully seated into the transaxle seal bore.
5. Insert the collet piece (2) of the J 45201 into the cooler line seal.
6. Insert the forcing screw piece (1) of the J 45201 into the collet (2).
7. Tighten the forcing screw (1) until snug.