pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Drive Axle Shaft Seal Replacement - Left|Page 10146 > < A/T - 4T65E Fluid Leaking From A/T Vent|Page 10143
Page 1
background image

Seals and Gaskets: Service and Repair
Drive Axle Shaft Seal Replacement - Left

Drive Axle Shaft Seal Replacement (Left)

Tools Required

*

J 44809 Output Shaft Seal Installer

*

J 45000 Seal Remover

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Place a drain pan under the transaxle to catch any spilled transaxle fluid.
3. Remove the left front axle shaft.

4. Using the J 45000, remove the axle seal from the transaxle and discard.
5. Clean the seal bore in the transaxle housing.

Installation Procedure

1. Using the J 44809, install the left axle seal into the transaxle.
2. Install the left front axle shaft.
3. Lower the vehicle.

Important: Dextron(R)III automatic transmission fluid is not compatible with this transaxle. If Dextron(R)III ATF is used, transaxle
failure will result. This transaxle uses GM T-IV fluid GM P/N 88900925.

4. Inspect the transaxle fluid level.

Drive Axle Shaft Seal Replacement - Left|Page 10146 > < A/T - 4T65E Fluid Leaking From A/T Vent|Page 10143