Trans Sport V6-191 3.1L (1990)
Compressor Clutch Coil: Service and Repair
Remove or Disconnect
1. Perform Steps 1 through 4 of "Clutch Rotor and/or Bearings" removal procedure. Mark clutch coil terminal location on compressor front head.
Clutch Coil Assembly Removal
2. Install J-33023 puller pilot on front head of compressor. Also install J-8433-1 puller crossbar with J-33025 puller legs as shown in illustration.
3. Tighten J-8433-3 forcing screw against the pulley pilot to remove the clutch coil.
Install or Connect
1. Place the clutch coil assembly on the front head with the terminals positioned at the "marked location.
2. Place the J-33024 clutch coil installer over the internal opening of the clutch coil housing an align installer with the compressor front head.