Rear Wiper - Partial Wipe Wash Pattern
-
New arm has improved tension and relocated washer nozzle (See Figure 2).
a.
Remove grommet from door panel and pull hose out approximately 6".
b.
Secure hose at door side and cut hose approximately 3" forward of grommet.
c.
Remove arm and blade from spindle and either transfer blade to new arm or install new blade (see item no. 1 above).
d.
Cut hose on new arm approximately 3" forward of grommet and install new arm on spindle.
e.
Splice hoses together using P/N 14047034 * connector (or equivalent) and reposition grommet to door.
Figure 3
3.
Add new check valve to washer system at washer bottle (See Figure 3).
a.
Cut hose approximate 1-1/2" from rear washer pump on washer bottle and splice hoses together with check valve, P/N 22102027 (note
flow direction indicated by arrow on valve).
Parts are currently available from GMSPO.
Labor Operation and Time Allowance:
Blade (Only) N 3616
.2 Hours
Arm (Only) N 3621
.2 Hours
Valve
T 1670
.2 Hours
Blade and Arm T 1693
.2 Hours
