Vibe L4-1.8L VIN L (2003)
4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
5. Pull the sensor harness and grommet out through the body.
6. Remove the bolt (2) which retains the wheel speed sensor harness (1) to the vehicle.
7. Remove the bolt (1) and nut (2) which retains the wheel speed sensor harness to the upper arm and suspension member.
8. Remove the wheel speed sensor retaining bolt (1) and remove the wheel speed sensor (2) from suspension knuckle.
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the wheel speed sensor (2) to steering knuckle.
Tighten
Tighten the rear wheel speed sensor bolt (1) to 8 N.m (71 lb in).
2. Install the bolt (1) and nut (2) which retains the wheel speed sensor harness to the upper arm and suspension member.
Tighten
Tighten the bolt and nut bolt to 5 N.m (44 lb in).
3. Install the bolt (2) which retains the wheel speed sensor harness (1) to the vehicle.
Tighten
Tighten the bolt and nut bolt to 5 N.m (44 lb in).
4. Reposition the wheel speed pigtail harness through the body. Install the grommet.
5. Connect the wheel speed sensor electrical connector (1).
6. Lower the vehicle.
7. Install the rear seat bottom and seat back. Refer to Seat Back Replacement - Rear Split Folding in Seats.
8. Install the fuel tank filler pipe protector (1). Secure with 3 bolts (2).
9. Perform Diagnostic System Check - ABS. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check
