Vibe L4-1.8L VIN L (2003)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Oil Level Indicator and Tube Replacement
Removal Procedure
1. Remove the oil level indicator from the guide tube.
2. Unclip the crankshaft position sensor electrical connector from the guide tube.
3. Remove the following components from the cylinder block:
^
The bolts
^
The guide tube (3)
4. Remove the guide tube seal (1) from the guide tube.
Installation Procedure
1. Use new engine oil in order to coat the new guide tube seal.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the new guide tube seal (1) to the guide tube. Secure the guide tube to the cylinder block using one bolt (3).
^
Tighten the bolt to 24 Nm (18 ft. lbs.).
3. Clip the crankshaft position sensor electrical connector to the guide tube.
4. Install the oil level indicator to the guide tube.