Vibe L4-1.8L VIN L (2003)
Muffler: Service and Repair
Muffler Replacement
Removal Procedure
1. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting.
2. Remove the bolts, the springs and the gasket from the Three-Way Catalytic Converter (TWC) (3) assembly:
3. Remove the hangers from the muffler.
4. Remove the muffler/tail pipe assembly from the vehicle.
5. Clean the seal mating surfaces.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the muffler/tail pipe assembly, with a new gasket, to the vehicle.
2. Install the hangers to the muffler.
3. Install the springs and bolts to the Three-Way Catalytic Converter (TWC) (3) assembly:
^
Tighten the clamp bolt to 43 Nm (32 ft. lbs.).
4. Lower the vehicle.