Vibe L4-1.8L VIN L (2003)
8. Open front hood, and locate the front end discriminating sensor - left electrical connector (1).
9. Remove the Connector Position Assurance (CPA) from the front end discriminating sensor - left connector.
10. Remove the front end discriminating sensor - left electrical connector (1) from the front end discriminating sensor - left (2).
Zone 2
1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Locate and remove the AM2 Fuse from the junction block (1), which is located near the base of the steering column.
IMPORTANT: With the SIR fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal
operation, and does not indicate an SIR system malfunction.
4. Disconnect the battery negative cable.
5. Remove the front door sill plate.
6. Remove the rear door sill plate.
7. Remove the center pillar lower trim panel.
8. Remove the front seat belt retractor.
9. Remove the side impact sensor electrical connector.
Zone 3
1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Locate and remove the AM2 Fuse from the junction block (1), which is located near the base of the steering column.
IMPORTANT: With the SIR fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal
operation, and does not indicate an SIR system malfunction.
4. Disconnect the battery negative cable.
5. Remove the lower steering column trim cover.
