Vibe L4-1.8L VIN L (2003)
5. Remove the HO2S 1 wiring pigtail and body plug (1) from the floor pan.
6. Remove the HO2S 1 (2) from the exhaust pipe.
INSTALLATION PROCEDURE
IMPORTANT: The HO2S 1 comes with an anti-seize coating on the new sensor. Take precautions in order to prevent removal of any of this coating
prior to installation.
1. Install the HO2S 1 (2) into the exhaust pipe.
2. Tighten the HO2S 1.
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
Tighten
Tighten the HO2S 1 to 44 N.m (32 lb ft).
3. Install the HO2S 1 wiring pigtail and body plug (1) into the floor pan.
4. Lower the vehicle.