Vibe L4-1.8L VIN L (2003)
Power Steering Pump: Service and Repair
Power Steering Pump Disassemble
Power Steering Pump Disassemble
Disassembly Procedure
1. Remove the power steering pump from the vehicle.
2. Thoroughly clean the exterior of the pump (4).
3. Remove the bolt and the inlet tube from the pump.
4. Remove the inlet tube seal from the inlet tube.
5. Remove the pump fitting from the flow control valve.
6. Remove the pump fitting seal from the pump fitting.
7. Remove the flow control valve from the pump.
8. Remove the flow control valve spring.
9. Remove the power steering pump pressure switch.
10. Remove the 4 bolts and the rear pump housing from the front housing.
11. Remove the pump housing seal.
12. Remove the retainer ring from the pump shaft.