Vibe L4-1.8L VIN L (2003)
Steering Gear: Service and Repair
Power Steering Gear
Power Steering Gear Replacement (FWD)
Removal Procedure
Notice:
The steering column must be in the LOCK position before disconnecting the following components:
+
The steering column
+
The steering shaft coupling
+
The intermediate shaft
+
The lower steering shaft
After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment of some
components during installation and result in possible damage to the SIR coil.
1. LOCK the steering column and verify the front wheels are in the straight ahead position.
2. Move the silencer pad away from the steering column.
3. Use paint in order to place match marks on the steering shaft coupling (3) and on the intermediate shaft (4).
4. Loosen the upper coupling bolt (7).
5. Remove the lower coupling bolt (6).
6. Remove the steering column hole cover (4) from the bulkhead.
7. Install the Engine Support Fixture.
8. Raise and support the vehicle. Refer to Vehicle Lifting.
9. Remove the front tire and wheel assemblies.
10. Remove the left engine splash shield.
11. Remove the right engine splash shield.
12. Remove the 2 outer tie rod ends (10, 15).
13. Place a drain pan under the vehicle in order to collect the fluid from the power steering system.
