Vibe L4-1.8L VIN L (2003)
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the front transaxle bracket and bolts.
^
Tighten the transaxle bracket bolts to 64 Nm (47 ft. lbs.).
2. Install the insulator to the mount bracket.
3. Install the front transaxle mount through bolt.
^
Tighten the transaxle mount through bolt to 52 Nm (38 ft. lbs.).
4. Install the 2 bolts to the front transaxle mount.
^
Tighten the front transaxle mount bolts to 39 Nm (29 ft. lbs.).
5. Install the left hand splash shield.
6. Install the right hand splash shield.
7. Lower the vehicle.
8. Remove the engine support fixture.
Automatic Transmission Mount Replacement - Rear
Automatic Transmission Mount Replacement - Rear
Removal Procedure
1. Install the engine support fixture to support the engine.
2. Remove the rear mount through bolt.
3. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
4. Remove the 3 nuts and 1 bolt securing the rear mount to the transmission support.
5. Lower the vehicle.
6. Remove the rear transaxle mount from the vehicle.
Installation Procedure