Vibe L4-1.8L VIN L (2003)
8. Remove the clip, then disconnect the cable end from the shift lever assembly.
9. Turn the lock, then disconnect the select cable from the shift lever assembly.
10. Remove the 4 nuts, then the shift lever assembly.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the shift lever assembly, then the 4 nuts.
^
Tighten the nuts to 12 Nm (9 ft. lbs.).
2. Install the shift cable into the shift lever assembly, then turn the lock clockwise to lock.
3. Connect the cable end of the shift cable to the shift lever assembly, then install the retaining clip.
4. Install the select cable into the shift lever assembly, then turn the lock clockwise to lock.
5. Connect the cable end of the select cable to the shift lever assembly, then install the retaining clip and washer.
6. Install the front floor console.