Vibe L4-1.8L VIN L (2003)
12.
Remove the three (3) screws in the front door side panel plate and then remove the side plate.
Caution:
Remove and install bolts one at a time to prevent the door glass from falling. Do not shake or move the vehicle to prevent the door glass from
falling.
13.
Remove the first design bolt (1), which is securing the front door glass, and install a second design bolt (4). Finger-tighten.
14.
Remove the first design bolt (2), which is securing the front door glass, and install a second design bolt (4). Finger-tighten.
15.
Tighten both bolts.
Tighten
Tighten to 9 N.m (80 lb in).
16.
Reinstall the three (3) bolt screws in the front door side panel.
Important:
Do not perform Steps 17 and 18 unless new butyl tape is required to seal the service cover to the door panel. Proceed to Step 19 if the butyl