Vibe AWD L4-2.4L (2009)
Splash Guard: Service and Repair
Engine Splash Shield Replacement - Left Side
Engine Splash Shield Replacement - Left Side
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the following components from the vehicle:
*
The 2 bolts (3)
*
The 4 retainers (2)
*
The engine splash shield (1)
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the engine splash shield (1) to the vehicle. Secure the splash shield with the 2 bolts (3) and the 4 retainers (2).
Tighten the engine splash shield bolts to 10 Nm (89 lb in).
2. Lower the vehicle.