Vibe AWD L4-2.4L (2009)
6. Remove the bolt (2) which retains the wheel speed sensor harness (1) to the vehicle.
7. Remove the bolt (1) and nut (2) which retains the wheel speed sensor harness to the upper arm and suspension member.
8. Remove the wheel speed sensor retaining bolt (1) and remove the wheel speed sensor (2) from suspension knuckle.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the wheel speed sensor (2) to the steering knuckle.
Tighten the rear wheel speed sensor bolt (1) to 8 Nm (71 lb in).