Vibe AWD L4-2.4L (2009)
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the back-up light switch and a new gasket to the transaxle case and tighten to 40 Nm (30 lb ft).
Note: Be sure to use boss B.
2. Install the clamps.
3. Connect the back-up light switch connector (1).
4. Connect the transmission cable with the clips (1, 2).
5. Install the air cleaner assembly.
6. Install the engine cover. Refer to Engine Cover Replacement (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Cover Replacement).
