Vibe AWD L4-2.4L (2009)
3. Remove the 4 bolts (1, 2, 3, 4).
4. Remove the wheel bearing and hub assembly from the knuckle.
Installation Procedure
1. Ensure the brake shield is on the knuckle.
2. Install the wheel bearing and hub assembly to the knuckle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the 4 bolts (1, 2, 3, 4) to the knuckle and tighten to 56 Nm (41 lb ft).
4. Align the hole (1) for the rear wheel speed sensor in a NEW dust deflector with the hole in the knuckle.
5. Use a hydraulic press and press tools, or use a hammer and a piece of flat steel stock, in order to install a NEW dust deflector.
6. Install the rear knuckle. Refer to Knuckle Replacement (All Wheel Drive) (See: Steering and Suspension/Steering/Front Steering
Knuckle/Service and Repair/Knuckle Replacement)Knuckle Replacement (GT) (See: Steering and Suspension/Steering/Front Steering
Knuckle/Service and Repair/Knuckle Replacement (GT)).
