Vibe AWD L4-2.4L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the AWD control ECU (2) with the bolts (1, 3) and tighten to 8 Nm (71 lb in).
2. Connect the connector.
3. Install the glove compartment door assembly.
4. Connect the cable to the negative battery terminal. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Service and Repair).
5. Check for AWD control ECU signal.
