Vibe AWD L4-2.4L (2009)
9. On the right side, install the bolt (2) and the nut (1) in order to retain the steering gear to the crossmember. Hold the nut and tighten the bolt to 82
Nm (60 lb ft).
10. Install the front suspension crossmember. Refer to Front Suspension Crossmember Replacement (All Wheel Drive) (See:
Suspension/Cross-Member/Front Cross-Member/Service and Repair)Front Suspension Crossmember Replacement (Two Wheel Drive) (See:
Suspension/Cross-Member/Front Cross-Member/Service and Repair).
11. Remove the wire supporting the steering gear.
12. Install the 2 nuts (1, 2) and the bolt (3) to the left front control arm and tighten to 89 Nm (66 lb ft).
13. Install the 2 nuts and the bolt to the right front control arm and tighten to 89 Nm (66 lb ft).