Vibe AWD L4-2.4L (2009)
10. Remove the bolts (1, 2) and pull out the switch.
If operation cannot be done as specified, replace the park/neutral position switch.
11. Loosen the bolts (1, 4) of the switch and set the shift lever to the N position (2).
12. Align the groove and neutral basic line (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
13. Hold the switch in this position and tighten the bolts (1, 4) to 5 Nm (448 lb in).
14. After adjustment, perform the inspection.
Installation Procedure