Vibe AWD L4-2.4L (2009)
2. Rotate the transmission cable nut (1) counterclockwise approximately 180 degrees and, while holding the nut in that position, push in the stopper
(2) until it makes 2 click sounds.
3. Install the outer part of the transmission cable to the shift lever retainer (1). Check that the position of the spring (2) is in the proper location, and
push in the stopper (4).
If the stopper (4) cannot be pushed in, slightly rotate the nut clockwise and then push in the stopper (4).
4. Using a screwdriver, pull the lock piece out from the adjuster case.