Vibe AWD L4-2.4L (2009)
Liftgate Window Glass: Service and Repair
Liftgate Window Replacement
Special Tools
*
J 24402-A Glass Sealant Cold Knife Remover
*
J 39032 Stationary Glass Removal Tool
*
Urethane Adhesive Kit GM P/N 12346392 or Equivalent
*
Isopropyl Alcohol or Equivalent
*
Cartridge-type Caulking Gun
*
Commercial-type Utility Knife
*
Razor Blade Scraper
*
Suction Cups
*
Plastic Paddle
Removal Procedure
Warning
If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
Note: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.
1. Open the liftgate.
2. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement (See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service
and Repair).
3. Remove the rear wiper motor. Refer to Liftgate Wiper Motor Replacement (See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Liftgate Wiper Motor Replacement).
4. Remove the rear spoiler. Refer to Rear Spoiler Replacement (See: Body and Frame/Spoilers, Flaps, and Air Dams/Spoiler/Service and Repair).
5. Disconnect the rear window defogger electrical connector (1).
Warning
If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
6. Cover the following parts to protect from broken glass:
1. The rear stowage compartment
2. The defroster outlets and A/C outlets
3. The seats and carpeting