Vibe FWD L4-1.8L VIN 8 (2004)
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the brackets (4), bolts (5), washers (3) and nuts (2) to the rear fascia (1), if removed.
Tighten the nuts to 5 N.m (44 lb in).
3. Install the U-clips (2) to the rear fascia (1), if removed.
4. Install the rear bumper fascia extension brackets (3) to the rear fascia (1), if removed.
5. Install the screws (5) and washers (4) to the brackets (3), if removed.
Tighten the screws to 5 N.m (44 lb in).
6. Install two way tape to the rear fascia extension. Refer to Molding/Nameplate Replacement - Exterior Trim (See: Exterior Moulding / Trim/Body
Emblem/Service and Repair/Molding/Nameplate Replacement - Exterior Trim) in Exterior Trim.
7. Peel back 25.0 mm of the two way tape liner from each end.
8. Position the rear fascia extension to the rear fascia and align to mounting holes.