Timing Chain and Sprockets Installation Guide
11. Install the crankshaft pulley retaining bolt using J 8614-01 to prevent crankshaft rotation when tightening the bolt.
^
Tighten the bolt to 142 Nm (105 ft. lbs.).
12. Install the power steering pump.
13. Use the following fasteners in order to secure the power steering pump:
^
Two bolts (1)
^
Two nuts
^
Tighten the power steering pump bolts to 37 Nm (27 ft. lbs.).
14. Install the right engine splash shield.
15. Lower the vehicle.
16. Connect the power steering oil pressure switch connector.
17. Rotate the crankshaft clockwise 1 revolution. Ensure that the plunger on the timing chain tensioner has released.
18. Complete the following steps if the plunger does not release:
18.1.
Use a screwdriver or your finger in order to press the timing chain dampener into the timing chain tensioner.
18.2.
Release the hook from the pin.
18.3.
Verify proper timing chain alignment after the plunger has released.
