Vibe FWD L4-1.8L VIN 8 (2004)
IMPORTANT: DO NOT allow any of the mineral base 525 viscosity refrigerant oil on the new O-ring seal to enter the refrigerant system.
4. Carefully slide the new O-ring seal onto the A/C refrigerant line.
5. The O-ring seal must be fully seated.
6. Connect the A/C line.
-
For compression style fittings use a back up wrench on the fitting (2) and tighten the fitting nut (1) to specification.
-
For banjo style fittings install the bolt retaining the banjo type fitting and tighten to specification.
7. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
8. Leak test the fittings of the component using J39400-A.