Vibe FWD L4-1.8L VIN 8 (2004)
Leak Detection Solenoid: Service and Repair
EVAPORATIVE EMISSION (EVAP) PRESSURE SWITCHING SOLENOID REPLACEMENT
REMOVAL PROCEDURE
NOTE: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the
EVAP canister for loose carbon before returning the vehicle to service.
1. Remove the EVAP canister (3).
2. Disconnect the electrical connector of the EVAP pressure switching solenoid.
3. Disconnect the 2 vapor hoses.
4. Remove the fastener (2).
5. Remove the EVAP pressure switching solenoid (1) from the EVAP canister.
6. Inspect the EVAP pressure switching solenoid and the EVAP control system for carbon particle contamination before replacing the EVAP
pressure switching solenoid.
INSTALLATION PROCEDURE
1. Inspect the EVAP pressure switching solenoid and the EVAP control system for carbon particle contamination before replacing the EVAP
pressure switching solenoid.
2. Install the EVAP pressure switching solenoid (1) to the EVAP canister.
3. Secure with the fastener (2).
4. Connect the 2 vapor hoses.
5. Connect the electrical connector.
6. Install the EVAP canister (3).