Vibe FWD L4-1.8L VIN 8 (2004)
Audible Warning Device Control Module: Removal and Replacement
Multifunction Alarm Module Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
Important: The multifunction alarm module is located under the instrument panel on the drivers side.
2. Remove the screws from the junction block and position the junction block in order to gain access to the multifunction alarm module.
3. Disconnect the multifunction alarm module electrical connector.
4. Disconnect the multifunction alarm module (1) from the rear of the junction block (2).
Installation Procedure
1. Install the multifunction alarm module (1) to the rear of the junction block (2).
2. Connect the multifunction alarm module electrical connector.
3. Reposition the junction block back into position. Secure the junction block with the screws.
4. Connect the negative battery cable.