Vibe FWD L4-1.8L VIN 8 (2004)
16. Clear the area of all people and loose or flammable objects.
CAUTION: Refer to SIR Inflatable Module Deployment Outside Vehicle Caution in Service Precautions.
17. Separate the 2 banana plugs on the SIR deployment harness.
IMPORTANT: The rapid gas expansion involved with deploying an air bag is very loud. Notify all people in the immediate area that you intend to
deploy the inflator module.
18. Connect the SIR deployment harness wires to the power source. This immediately deploys the side impact module.
19. Disconnect the SIR deployment harness from the power source after the air bag deploys.
20. Seat one banana plug into the other in order to short the deployment harness leads.
21. If the air bag did not deploy, disconnect the adapter and discontinue the procedure. Contact the Technical Assistance Group. Otherwise, proceed to
the following steps.
22. Disconnect the pigtail adapter from the inflator module as soon as possible.
23. Inspect the pigtail adapter and the SIR deployment harness. Replace as needed.
CAUTION: Refer to SIR Deployed Inflator Modules Are Hot Caution In Service Precautions.
24. Put on a pair of shop gloves in order to protect your hands from possible heat and irritation when you handle the deployed inflatable restraint front
side impact module.
25. Remove the side impact module from the J 39401-B.
26. Dispose of the deployed inflator module through normal refuse channels.
27. Wash hands with a mild soap.
Frontal Air Bags - Vehicle Scrapping Procedure
