Vibe FWD L4-1.8L VIN 8 (2004)
INSTALLATION PROCEDURE
IMPORTANT: The HO2S 1 comes with an anti-seize coating on the new sensor. Take precautions in order to prevent removal of any of this coating
prior to installation.
1. Install the HO2S 1(1) into the exhaust manifold.
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
2. Tighten the HO2S 1.
Tighten
Tighten the HO2S 1 to 44 N.m (32 lb ft).
3. Connect the electrical connector (2) of the HO2S 1.
4. Install the engine cover (1).
5. Secure the engine cover (1) with the 2 fasteners.
Tighten
Tighten the two fasteners to 7 N.m (62 lb in).
6. Install the 2 plastic retainers.