Vibe Crankshaft Position Sensor Location - Page 738
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the two bolts (3) that secure the stone shield (1).
3. Remove the four retainers (2) and the stone shield (1).
4. Disconnect the CKP sensor electrical connector.
5. Remove the one hold down bolt (2).
6. Remove the CKP sensor (1) from the front cover of the engine block.
INSTALLATION PROCEDURE