Vibe FWD L4-1.8L VIN 8 (2004)
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the 2 shift cable grommet retaining bolts.
Tighten the bolts to 5.0 Nm (44 inch lbs.).
3. Install the inflatable restraint sensing and diagnostic module from the instrument panel. Refer to Inflatable Restraint Sensing and Diagnostic
Module Replacement in SIR.
4. Install the gearshift selector assembly. Refer to Gearshift Selector Assembly Replacement.
5. Install the shift cable clamp on the shift cables, then install the 2 retaining nuts.
Tighten the nuts to 5.0 Nm (44 inch lbs.).
6. Connect the shift cable ends to the transaxle.
7. Install the shift cable washers and retaining clips (1).
8. Install the shift cables into the bracket.
9. Install the shift cable bracket retaining clips (2).
10. Connect the negative battery cable.
